Lifeline Endure Specifications

• MSDS
• Lifeline Endure Label

To view and/or print MSDS sheets or labels you need Acrobat Reader. If you don't have Acrobat Reader installed on your computer, click here for a free download.

Lifeline Endure™ Deck Finish Application Instructions

(Printer Friendly Version Here)

SURFACE PREPARATION
For new, pressure treated decks allow the wood to dry for at least three months before applying Endure. Clean surfaces with Log Wash and a pressure washer. If gray wood is present, use Wood Renew.

For the best performance of Lifeline Endure Deck Finish remove all grey oxidized wood then sand the deck and railings with 60-80 grit sandpaper. After sanding the surfaces should be cleaned with Log Wash and thoroughly rinsed to remove any wood dust. Use pH Strips to verify that all cleaner residue has been removed. Contact any Perma-Chink Systems location for information about the proper use of pH Strips. DO NOT USE ENDURE DECK FINISH ON SURFACES THAT HAVE BEEN BRUSHED OR RUBBED WITH STEEL WOOL. IF YOU DO, RUST SPOTS MAY APPEAR UNDER THE FINISH. Endure Deck Finish should always be applied within five days of cleaning.

COVERAGE RATE
One gallon of Endure Deck Finish will cover approximately 300 to 400 square feet on unfinished wood depending on wood type and porosity.

APPLICATION
Endure Deck Finish can be applied with an airless sprayer, brush or pad. Do not apply when the surface temperature is below 40° F or above 90° F. DO NOT APPLY TO HOT SURFACES OR IN DIRECT SUNLIGHT. Back brushing is required to work the finish into the wood for optimum performance. Always keep a wet edge to avoid lap marks. Allow the finish to dry 72 hours before replacing deck furniture.

CLEANUP
Clean with warm, soapy water.

MAINTENANCE
A periodic maintenance coat of Endure Deck Finish may be applied directly over existing Endure as needed. Apply in a thin coat to avoid film build-up. Clean deck with Log Wash before applying.

© Perma-Chink Systems, Inc. 06/2008